Wildat07

Recently added some more fans to my 5000D case but was out of Fan and RGB slots on my Commander Core. Got a Commander PRO to expand. I plugged the ML fans into the Core and the RGB into the RGB Fan LED Hub. The LED Hub is plugged into LED 1 on the PRO. On the RGB Fan LED Hub, I plugged them into 1, 2, and 3. Understand it is serial and needs to be in order. In iCUE, I identified the fans as ML and that there were three of them. The second fan is being identified as both 2 and 3. If I change iCUE to 4, the third fan will light up. There is nothing plugged into slot 4. If I try to change it from ML fans to 8-LED Fan Series, something even stranger happens. The fan that was previously 1 is no longer lit. Fan 2 becomes Fan 1. Fan 3 lights up as fan 2. Any advice?

Appreciate it! The auto-detect was not finding all the lights. I manually set it to x8 mode and all the lights came on. Thanks!

I have 6 ML 120 RGB pro fans in the case. Two of them came with the H100i Elite Capellix. Recently noticed that two of the fans ( the two that came with the AIO) have a dead zone in them. At first I thought it was a setting in iCUE but there is nothing there. All the other fans are fully lit. In the picture I put it on the Corsair Yellow profile to verify there was not setting I missed. Just the AIO fans have the dead zone. Is this a common problem the the ML 120 RGB?

Thanks! I appreciate it. I plugged it into a header on the motherboard to test it out and it worked. I honestly didn't think it would be trying to draw power like that to cause an issue. Guess the SATA was only providing power for the lights. The other header was being tied up by a Wifi/Bluetooth card which I hardly ever use. Will disable that for now.

Scoured the forums for a couple of hours looking for a solution but didn't find one. Hope this is not a repeat of one I missed. I installed a iCUE H100I Elite Capellix to my system and liked the fans on them. I ordered a ML 120 PRO kit and replaced the stock fans. I connected these fans to the Commander Core that came with the H100 and they work perfectly. I wanted to replace the RGB in my case with the RGB LED Lighting Pro strips so it would sync with the pump and fans. I ordered the expansion kit since I already had the LNP that came with the fan kit. Due to limited USB headers on my MOBO I installed a USB header port splitter so that I could plug in both devices. The fans and pump are running fine and iCUE detected them while connected to the splitter. It is not detecting the LNP in iCUE. I ran USBDeView and Windows is detecting the LNP. When I unplug the USB from the LNP Windows makes the noise its disconnected.