I built my first PC a month or so ago and everything’s going pretty well, but I still have a few concerns / questions regarding the fan setup.
When I built it I installed a Corsair Hydro 100i RGB Platinum pump and two fans to the front of my system. This all connected fine and was read in the iCue software so I could control the pump and 2x fan speeds via a curve in the app. All good.
Since then I replaced the 2x exhaust fans at the top and back of my case with a further 2 Corsair fans. I posted here recently to say that the iCue software was only controlling the pump and 2 original fans so I was told I need the Commander Pro unit as well.
Jump to today and the Commander Pro is installed and has my 4 pumps all connected to it. Within the iCue software, under the Commander Pro, I can see my 4 fans and control their speeds. There is a separate section now for the pump which still shows the pump and two fans, though here I can only control the pump curves.
So, after that it of background, my queries are:
1) is the above setup correct? Should I be seeing the 4 fans under the Commander Pro tab in iCue and the pump separately?
2) if so, why are two fans still showing as connected with the pump?
3) lastly, for the 4 fans I’ve set them to the same curve, but do you generally run the fans at different speeds? The two exhaust fans at the back and top faster / slower than the others etc.
Thanks in advance for reading through the long post above. If you need pictures or screenshots of the iCue setup please let me know!
Thanks again.