BoneSaw Gaming

I’m sorry one other thing is I also bought the lightning node pro with 4 strips to wire up as well. This forum has been a lifesaver this far ❤️

I didn’t realize there was a 13th page until just now. I kept refreshing page 12 and seeing nothing new lol. I’m quite sure I was able to find the right diagram for my needs. Thanks to your attention to detail in the diagrams. Also I just bought 2 ql120 triple kits to ensure I have enough lighting node pros. I’m going to be returning some fans as I bought singles before I knew exactly what I was doing. At This stage could you just provide me of a list of icue products requires to run 9qls? 3 of which will be controlled by aio. Side note I’m building in the 500d rgb se so I have the CoPro and and an rgb hub in there already.

I appreciate it. That should make things slightly less complicated.

Thanks again zotty. My biggest concern is the correct writing diagram, but I can’t figure out how to insert said picture into this forum. Sorry one of my first times actually interacting with a forum rather than just reading it. 9ql’s and 4 strips are what I’m looking to sync together through icue.

Gpu is the ASUS rog strix 2080ti OC

Hello again zotty, I was doing some more reading. And I have decided I might as well go push pull on the 360mm front rad. So I’m going to purchase 3 more ql 120’s this time bundling them and receiving the lighting node core. I’m also going to purchase the lighting node pro with 4 strips. Could you just provide a link to the correct diagram, I’m doing all this on my phone and it’s hard to navigate the forum on here. Anyways your diagrams are absolutely amazing from what I’ve seen thus far. I was seriously doubting be able to sync every thing up. But now I’m confident it will all sync up. Also I’m assuming I just plug my rgb header from video card into one of the led channel ports on the commander pro? Thank you for your time zotty!

Hello zotty, I am still waiting on parts right now.but I will be building a 500d soon, I bought 4 single ql 120’s and 2 single ql 140’s. Swapping out the included ll120’s for 120 qls 2 140 on top and 1 120 in back. I didn’t think I would need to buy the combo pack because the 500d came with the commander pro and a hub. So I bought singles to save money. I also bought an rgb enabled 2080ti and 360mm aio cpu cooler. After reading about 6 qls maxing our the commander pros capacity, I’m thinking I might to be an additional lighting node pro perhaps? Not sure. And to further complicate things, isn’t it basically the same price for the lighting node pro with rgb strips as opposed to without? First time builder here and it’s a lot to take in.