Grid21 Posted November 5, 2019 Share Posted November 5, 2019 Right now I am running 4 sets of Corsair Vengeance Pro RGB ram. Model:CMR16GX4M2C3000C15 It's overclocked using DOCP to 3000Mhz, but I was wondering if anyone has been able to get a set of these to 3200Mhz and if so, what were your voltage, timings, and anything else set at? I have a Ryzen 7 2700 CPU and an Asus ROG Strix X470-F Gaming Motherboard. How could I push the ram further if it's even possible even though DOCP is already enabled. Link to comment Share on other sites More sharing options...
A Computer Guy Posted November 6, 2019 Share Posted November 6, 2019 What is the version of your memory kit? A full load of ram may reduce the maximum frequency you can attain due to the load on the memory controller. Here are some helpful links... - amd-ryzen-memory-tweaking-overclocking-guide - ryzen-dram- - calculator Link to comment Share on other sites More sharing options...
Grid21 Posted November 6, 2019 Author Share Posted November 6, 2019 What is the version of your memory kit? A full load of ram may reduce the maximum frequency you can attain due to the load on the memory controller. Here are some helpful links... - amd-ryzen-memory-tweaking-overclocking-guide - ryzen-dram- - calculator See attached Screenshot. That should give you everything you need to know. NOTE: There are 4 DIMMS of this ram in my slots. Link to comment Share on other sites More sharing options...
c-attack Posted November 6, 2019 Share Posted November 6, 2019 Generally, yes... a 3000 kit normally can bump up one more standard run with appropriately changed timings. I would try 3200 16-18-18-36 1.35v as a starting point. Let the BIOS pick the secondary and tertiary timings (Auto). You'll have to see if VCCSA or VCCIO voltage needs to be tweaked. Asus boards have a history of massively inflating this value and it is usually better set manually. However, the one very large catch is a lot of 2000 series processors and 400 series boards hit a brick wall around 3000 MHz on the RAM. Success seems to be very dependent on the board and CPU. Link to comment Share on other sites More sharing options...
Recommended Posts