adslegend Posted January 18, 2005 Share Posted January 18, 2005 Hi, if I want to replace the 120mm fan inside hydrocool will I have to cut/solder any wires or is it just a straight unplug and swap? Thanks in advance :o: Link to comment Share on other sites More sharing options...
KaptCrunch Posted January 18, 2005 Share Posted January 18, 2005 once the 4 screws holding the cover removed (lower corners) its a 2 wire plug, thing is the silicone glue is a bugger to remove an need a small allen hex key to remove control board to get at it. careful not to loose the 3 botton's the top pin is positive while lower pin is negitive Link to comment Share on other sites More sharing options...
adslegend Posted February 12, 2005 Author Share Posted February 12, 2005 Thanks I now have a YS-Tech pushing 125CFM at max rpm, and about the same noise as the stock fan. Running in normal mode still pushes more air :D: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.