cortmans Posted March 22, 2018 Share Posted March 22, 2018 I recently bought 6 LL120 fans and a lighting node pro. The LL120 fans come with two cables attached to them, one 4 pin connector and and this RGB cable or something along those lines. I bought a commander pro for the 6 4-pin cables to control voltage and rpm, and I was going to use the existing RGB LED controller in the 570x but apparently that is incompatible with the LL series fans if you want to control RPM and the lighting, so what should I do to be able to control PWM, and lighting for the LL series fans? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted March 22, 2018 Corsair Employee Share Posted March 22, 2018 You can do it all with the Commander PRO. Plug the 4-pin PWM connector directly into the COMMANDER PRO to control fan speed. Plug the RGB connector for each LL fan into the 6-port hub included with your LL kit, then connect that hub into an RGB LED channel on the COMMANDER PRO. If you have any questions or would like to check out some diagrams, check out the link in my signature. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.