Yvonneay Posted July 29, 2019 Share Posted July 29, 2019 Hey y'all, I've searched and searched for this particular issue with no luck. I keep finding the whole strip is flashing/flickering, or that it doesn't connect to other strips to power them... I guess I have a more unique situation?? This happens with or without iCue software running. The last 2 LEDs on a strip connected DIRECTLY to my Lighting Node Pro are flickering. This only started recently as I've had this PC built for a bit over a year and it was not doing this before. I only recently noticed it, however. I do not know if a firmware update caused this, or if it's faulty LEDs? In any case, it's very distracting now that I know of it and I can see it out of the corner of my eye. I see other people having issues running power through the strips, I do not believe this is the case since this one is directly connected to the Node Pro and it only has 2 LEDs flicker not all of them. Any and all support is welcome, even the "did you turn it on and off again?" ones... because I might have not done that... even though I did. Thanks! Link to comment Share on other sites More sharing options...
solarity Posted July 29, 2019 Share Posted July 29, 2019 Did you turn it off and on? :p Are you saying it is always the last two LEDs that flicker no matter if you have 1, 2... or 6 strips connected? i.e. on 2 strips only LED 19 and 20 are flickering? Have you tried swapping out strips in different orders? Link to comment Share on other sites More sharing options...
Yvonneay Posted July 29, 2019 Author Share Posted July 29, 2019 (edited) I guess I just have the one on the node, got lucky I guess and didn't have to have any plugged in to it or vice versa. So it's just the one strip attached to the node. I tried switching the strips to different nodes, and it's definitely the strip... I haven't tested if it does it regardless if it's with another strip attached or not because I didn't want to take my whole RGB strip system out, it's a pain in the *** to build a nice looking PC... Basically I'm lazy and didn't want to have to take it apart and put it back together if I didn't need to. I'm a bit bummed because even though I saved the receipt for the strips, and I saved a lot of boxes for warranty, if this is a strip issue I dunno if I have this particular box to send it in for warranty. :( EDIT: I moved the strips around and regardless of order, or placement, in sequence or not, the strip flickers at that point. Opening up a ticket with Corsair as I believe to have a damaged strip even though it's been a year since I have had it... :( Edited July 29, 2019 by Yvonneay Link to comment Share on other sites More sharing options...
Recommended Posts