3three3 Posted August 11, 2012 Share Posted August 11, 2012 Experiencing same readings (128degrees) but figured it was bogus. However, I am getting occasional Blue screen & crash dumps, my BIOS seems to keep losing the Drive & I need to go find it on start up periodically. Also, the Firmware Updater Tool (5.o2) is not seeming to have an effect on my FW Version. Stuck on 1.2 instead of upgrading to 1.3 or so. Can't seem to figure this out. Very happy with the speed of this drive, but less than satisfied, to say the LEAST, about the issues. Link to comment Share on other sites More sharing options...
Wired Posted August 11, 2012 Share Posted August 11, 2012 Make sure the SSD isn't on a JMicron SATA port, but on an AMD SATA port. Then right click the tool and select run as admin. Link to comment Share on other sites More sharing options...
3three3 Posted August 11, 2012 Author Share Posted August 11, 2012 All 6 on-board SATA ports for my MoBo are AMD. The JMicron is for the eSATA & PATA ports. I tried [Run as Admin] but am still stuck on 1.2 Rev. I updated the BIOS just because it was Very overdue, and same. I noticed they are set to IDE, not AHCI, in BIOS. Would that make the difference? I am not sure what difference it makes other than being able to boot from Optical drives on some ports when set one way vs the other. I know just about enough technically to get my self in over my head. Well, thanks for any insight you may have. By the way, AHCI is on (set to value=0) in HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Msahci. Link to comment Share on other sites More sharing options...
CutMyThoat Posted August 11, 2012 Share Posted August 11, 2012 I was only able du succesfully flash firmware when changing to generic driver in device-manager. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.