SPL Tech Posted July 7, 2020 Share Posted July 7, 2020 (edited) My fans are not following the commands issued by my custom fan profile at all. The temperatures are way off. I am finding there is a +8C bias between what the fans and my pump is doing relative to the command. That is, if the water temp is 37C and I tell the fans to run at 0% at 37C and 100% at 45C, then the fans will run at 100% at 37C. In order to get the fans to correctly run at 0% at 37C I have to advance the profile from 37 - 45C to 45- 53C. So basically, I have to shift all readings to the right by 8C to get them to be accurate. What gives? See attached. Edited July 7, 2020 by SPL Tech Link to comment Share on other sites More sharing options...
BlaiseP Posted July 7, 2020 Share Posted July 7, 2020 Change the fan curve "Sensor" to "Commander Pro Temp" (it may just be "Temp"), currently you are basing this fan curve off your first RAM stick. Link to comment Share on other sites More sharing options...
Recommended Posts