cakesg

I'm gonna do some more monitoring, but something I have experienced is that the RGB is also off sometimes for my GPU block and CPU block. Also I am running the Hydro X default curves

I was finally able to log my coolant temp and I found that there was no increase in temperature for the coolant

Im using the Water temp on my Hydro X setup

I have 6 ML140s in my case. Every now and then, theyll randomly speed up a lot for about half a second to a second and then go right back down. What could cause this problem? All 6 fans are linked to a commander pro.

no they dont

No it doesn’t work

Yes the lighting config is all correct. It happened out of nowhere, was working the night before. Now only the pump lighting works and I have tried switching channels on the commander pro(which didn’t work). The fans still work. I have the hydro x components daisy chained(cpu->gpu->pump->commander pro)

My RGB is no longer working, only the pump. The GPU and the CPU blocks do not light up anymore

My radiator is making water dripping noises. When I turn the pump to 100% after startup, there are always air bubbles but I dont see any leaks anywhere. Could it be the radiator is broken? Should I drain it and do an air pressure test

What happens if the coolant goes above 60c? I ran a stress test overnight and the fans turned off sometime. The coolant temp was around ~67c when I woke up. Will this damage my pump(as I read the maximum operating temperature is 60c) or my acrylic tubing?

My loop has quite a bit of particles in it(probably from me leaving the cap open while leak testing. One of these particles have gotten trapped into one of the GPU fins. Should I be worried about this?