[Corsair Obsidian 1000D Build Log/How to Guide]

EPIC!!!

 

Nice work Sir!

 

Few more pictures. Computer and my setup.

 

 

 

[Corsair Obsidian 1000D Build Log/How to Guide]

No worries man.. good luck on your quest!

 

Finally done!!

[Corsair Obsidian 1000D Build Log/How to Guide]

you can just about see it through the hdd caddy, may take a fair bit of material removal to make it accessible dude

 

Then I will get some soft tubing and try it. Thank you for the help. It truly helps with this build.

[Corsair Obsidian 1000D Build Log/How to Guide]

Glad you asked that... i ran soft tubing in the back and pre-attached the tubing before fitting the rads.. as i fed the rads and cables in i also fed that tube in.. i can't think of any other way to do it.. hope that made sense dude

 

I am going to try and figure this out. I may even drill a hole to accommodate the tube. I may also try your solution.

[Corsair Obsidian 1000D Build Log/How to Guide]

yeah sorry buddy i am hard tube..

 

http://i.imgur.com/YBpQHzjl.jpg

 

Zotty, do you have the tube routing diagram?

 

I was wondering how you ended up routing the front radiator tubes. You connected the two middle ones and have the front right tube split into a drain. But how did you route the leftmost tube? I find the space very constricting and I am having trouble routing from there.

[Corsair Obsidian 1000D Build Log/How to Guide]

Update..

 

Rads/Fans/Pump/Drains (front and back)/GPU Block/flow-temp sensor/filter all fitted

 

this was my final RGB/Fan Control setup

 

http://i.imgur.com/fBgDuFrl.png

 

 

 

Excuse the AOI and its cable mess. so far i have managed to keep it as a running system while adding bits here and there.

 

http://i.imgur.com/lThNYvAl.jpg

 

 

I decided to try the GPU in the ITX mounts to give a bit more room (lol) running tubing behind the GPU as well as give me room to add a small wifi/BT card. Should be noted the the cover/plate for the itx rear IO and its PSU has to be 'modded' so you can use the case itx pci slots without said itx being fitted (hope that made sense lol..

http://i.imgur.com/YEHXV6il.png

 

http://i.imgur.com/QcItHKSl.jpg

 

Not so sure i will stick with the fittings that run from GPUU to upper Rad in the below image.. i feel it suddenly looks 'industrial' so may do a ben or 2 there

 

http://i.imgur.com/HWpuVHEl.jpg[/img]

 

 

Hi. I am new to this thread, but I have to say that it is amazingly helpful. I just got 1000D and plan to do a similar build to yours. I looked at your latest diagram and it seems so much simpler that your previous ones. I do have a question on XSPC hub. Is this the "8 Way PWM Splitter Hub - SATA Powered"? Can you control the fan speed and RPM with this hub?