Steve151 Posted September 6, 2019 Share Posted September 6, 2019 I am trying to control a 40mm high speed chipset fan for an add in card. The problem is, the card can get very hot, so the fan is capable of 11,000 rpm. At that speed, it is extremely noisy. When I try to use the commander pro, I'm limited at 5000 rpm, despite being able to set the rpm in the graph. % control works, but this is only a fixed setting. I want it to vary with one of the temp sensor. Is there a solution? Link to comment Share on other sites More sharing options...
Recommended Posts