GunsR_Us Posted September 10, 2019 Share Posted September 10, 2019 (edited) After my old mouse not working anymore, so I decide to replace it with a brandnew Corsair Harpoon (Wire), plug it to the old mouse USB port directly on the Maximus VII Hero mainboard. My Windows 7 recognize The Corsair Harpoon quickly, and it working just fine like the other mouse I have in the past. But the problem is, I shutdow my PC and the next everytime I turn my PC on again, after Windows booting up to desktop screen, my mouse seem not response for about 5-10 seconds without lightning on the Corsair logo. After that the lightning is on and my mouse seem ready to begin to work. I try plug it to another PC with Windows 10 and it work normal, response right away. I've been trying multiple solutions for 3 days, mess up with my HID driver, USB driver and end up non of those can help. I've installed and reinstalled Corsair Link 4 and iCUE for couple of times. Also try to plug the mouse to all of my PC's USB port. And the problem still present. P/S I feel like Windows take 5-10 seconds to rerecognize the mouse, or the mouse just take it time to decide with driver suit it to work, I don't know ! Edited September 11, 2019 by Guns*R_Us Link to comment Share on other sites More sharing options...
jiyunohane Posted September 18, 2019 Share Posted September 18, 2019 similar issue here. windows 7 working fine until last . CRP DISABLD popup show every time I plugged the Harpoon RGB mouse. Mouse has no light. PC(and also iCue) could not detect the mouse. Also tried these -uninstall and then reinstall iCue to the lastest version(3.19.120). -Plug and Unplug, even try different USB ports. The problem still occur. I found that if I plugged the mouse and then boot my PC, my PC takes a lot of time to start windows. Link to comment Share on other sites More sharing options...
jiyunohane Posted September 20, 2019 Share Posted September 20, 2019 (edited) Updated iCue to the lasted version(3.20.80). Already tried soft reset the mouse. Still not solved. Need to try hard reset. Edited September 20, 2019 by jiyunohane Added info Link to comment Share on other sites More sharing options...
Recommended Posts