Minne

yes it is behaving in commander pro. it's working like its supposed to without a preset rpm or %

Okay i got all 4 fans set up in commander pro. got the 2 radatior fans set up to the temp of the coolant. what do i set the other two fans up under? processor or video card? and thank you for your help today

okay so i set it to 40% and this is what i got

Would it be ok to hook both fans up to a commander pro? I just need to hook it up. Might get a more stable connection.

Yes both fans respond. Last night I set each one to 0 rpm to test and they both responded. Okay i switched the cables and now the other fan is the low rpm one and the other one is working fine. I uninstalled and re installed and nothing changed. I set the set rpm to 900 and both fans responded and are spinning at 900 rpm. attached are two screen shots. the rpm on quiet seems to be lower because the coolent is pretty low at the moment. should i just run a fixed rpm? what do you suggest?

What rpm should the pump be at on quiet mode? I will try switching them when I get home. Should be home in a couple hours. So the second fans rpm seems about right for the coolant temp? If the fans switch places and the other one goes low rpm then what? One connector could be bad. I could just plug the low rpm one into commander pro for a fix?

Yes the metrics change so it’s not frozen. I can take a screen shot when I get home from work. No fan curve. Everything in Icue is stock. I have restarted icue and restarted pc. Maybe un install and re install? I just got some ml pro case fans with commander pro. Is it bad to hook the radiator fans up to commander pro?

Is it normal for them both to be different rpms? There both in quiet mode and the top one is at 350 rpm and the second one is at a higher rpm. Like 600. I have them hooked up to the pump like there supposed to be. My temps are fine. Temp is around 45 and coolant is at 28