knives88 Posted March 12, 2019 Share Posted March 12, 2019 I recovered from a friend a H110i with some problem (disconnected by mistake the power cable when the PC is on):. - Fan Header 1 always at 100% and the speed cannot be changed by CL / iCUE - Fan Header 2 does not work / is not seen by CL / iCUE - The pump in performance mode cannot be changed from CL / iCUE From the CL / iCUE you can only view the Fan Header 1 / Pump / Liquid Temperature without problems. Is it possible to reload the firmware? In any case for me these are not problems, because it will be installed on the second PC ( nas 24h/7day ) and the fans will connect them directly to the motherboard and the classic "hum" of the CoolIt pump does not bother me, indeed I like it. :D: Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Jam Posted March 13, 2019 Corsair Employee Share Posted March 13, 2019 Hello, Do you have the Link cable installed? If so, could you try a different Mini-USB cable? Route a standard Mini-USB cable from the cooler, to the rear I/O USBs. See if you can control the cooler then. Link to comment Share on other sites More sharing options...
knives88 Posted March 13, 2019 Author Share Posted March 13, 2019 Yes the cable is connected, my motherboard only has an internal USB 2.0 port and I use an NZXT hub, tried also without hub. I'll try with a mini-usb cable. Thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.