Jump to content
Corsair Community

auto restore normal operation is missing


Radltruhe

Recommended Posts

100%

 

At first I thought it was the 'minimum' setting, i.e. if the temp comes down to under the minimum, then restore normal operation.. but no, not the case.

 

It feels like this should be a default setting?! Surely? Otherwise if I leave a queue of movies to transcode when I go to bed, the encodes take an hour and my system runs on full blast all night? Surely not.

 

Does anyone know how to handle this?

 

Ta,

Jea

Link to comment
Share on other sites

  • 4 months later...
  • 4 months later...

Hi,

 

I'm having the same problem!

 

I know what triggers my 'not normal' operation, I want all my fans to go on 100% when my gpu hits 75 degrees to flush my case as it were.

 

So I set that to happen but once it's triggered they then stay on 100% even if my gpu goes back to idle temps until i manually press 'restore normal operation'.

 

This sucks. anyone found a fix?

Link to comment
Share on other sites

  • 2 years later...

hi, use this batch file.

the batch file will wait 30min., close CorsairLink4 and reopen it.

 

@echo off
REM wait 30 Minutes after Corsair Alarm
echo "CORSAIR ALARM ACTIVE"
timeout /T 1800 

taskkill /F /IM CorsairLink4.exe
taskkill /F /IM CorsairLink4.Service.exe

start "" "C:\Program Files (x86)\CorsairLink4\CorsairLink4.exe"

EXIT 0

Link to comment
Share on other sites

×
×
  • Create New...