BlaZeD Posted July 9, 2020 Share Posted July 9, 2020 Hello, Everything in my build is iCue compatible except for the GPU. I was contemplating pulling my EVGA RTX 2080 ti XC Ultra apart and disabling the EVGA LED's and installing a Corsair LED strip in the card. I'm curious if anyone has ever disabled EVGA's crappy RGB and installed a LED strip in the shroud to light it up. Maybe not disable them as I can just shut them off, but I'd like anyone's feedback on adding a strip to it so I can sync it with everything else. I'd find it hard to believe if no one has done this :laughing:. Any feedback would be appreciated. EVGA's RGB is super antiquated compared to iCue and it's bugging the crap out of me! Thanks! Link to comment Share on other sites More sharing options...
DevBiker Posted July 10, 2020 Share Posted July 10, 2020 Have you seen these: https://www.v1tech.com/product-category/backplates/ Link to comment Share on other sites More sharing options...
BlaZeD Posted July 10, 2020 Author Share Posted July 10, 2020 Have you seen these: https://www.v1tech.com/product-category/backplates/ I have and I'm most likely going to get one. But I'd like for the 2080 ti lettering on the side of the card be controlled in iCue. I'm sure it's possible, but before I go taking my card apart I was hoping for some feedback. Thanks for the reply! Link to comment Share on other sites More sharing options...
Recommended Posts