Jump to content
Corsair Community

iCue RGB Strips Not Being Detected


Buzz290

Recommended Posts

I recently finished my first PC build and my two Corsair RGB products are three fans and some RGB strips. However, on iCue, only my fans are able to be customized. I have been told I have to add the lights manually but I'm not sure how to do that. Thank you.
Link to comment
Share on other sites

The strips need to be connected to an interface device. That is likely the Lighting Node Pro that came with your fans or possibly the Commander Pro if you bought one. If the fans are in channel 1, then strips can go to channel 2.

 

In iCUE, go to the Node Pro device picture and select Lighting Setup. In the drop down menu, "RGB LED strip" should be one down from the top. Select it, then an additional box will appear to the right for you to designate the number of strips. Now you are set-up. Go back to the Lighting Effects tab for channel 2 and use the + to add lighting.

Link to comment
Share on other sites

×
×
  • Create New...