metalist Posted August 9, 2020 Share Posted August 9, 2020 hello guys. I have this case with the H150I PRO. with the case I got the 6-port LED hub, to this hub I connected the H150I fans and the case fans directly to the motherboard. Everything works fine. I tried to add a QL120MM fan, I cannot connect the RGB to the 570X hub or the motherboard (MSI). From a few searches I realized that the hub is not really suitable and also motherboard not to. Is there a way I can connect the fan to the hub or to motherboard that will work well? Or do I have to add the lighting node pro ?? And if I do add, then how exactly Everything will work? Can I connect QLfan120mm case fans and H150I fans to the LED 570X hub led and get full control of everything Through the node pro and the software? I will need more cables with it? I'm just a little confused Thank you very much Link to comment Share on other sites More sharing options...
metalist Posted August 10, 2020 Author Share Posted August 10, 2020 Someone ??? Link to comment Share on other sites More sharing options...
Johnny_B500 Posted August 10, 2020 Share Posted August 10, 2020 You can't mix and match different fan types on a single hub. If I am understanding correctly, you would need another Lighting Node Pro and another RGB Hub to run your QL fan. Alternatively, you could use a Lighting Node Core which is basically the Node Pro and RGB Hub combined. For now though, I highly recommend you refer to the RGB FAQ and Setup (which includes extensive wiring diagrams) linked below: Zotty's CORSAIR RGB Hardware and iCUE Eco-System FAQ https://forum.corsair.com/v3/showthread.php?t=173880 Link to comment Share on other sites More sharing options...
metalist Posted August 10, 2020 Author Share Posted August 10, 2020 But if I add NODE PRO and connect it to the rgb led hub, can I mix any type of rgb fans , in the rgb led hub? Link to comment Share on other sites More sharing options...
vexed Posted August 10, 2020 Share Posted August 10, 2020 As a fellow 570x owner i use 6 LL fans wired into a commander pro with the H115i fans hooked onto the sys fan header (using stock fans) and the usb from the cooler onto the commander unit and the commander connected via the usb header on the board. i used a guide Zotty made which was crazily helpful located here https://forum.corsair.com/v3/showthread.php?t=173880 wiring diagram Zotty did is here https://i.imgur.com/XSDWsneh.png to how i've wired them up just add the h115i to the mix - Vex Link to comment Share on other sites More sharing options...
metalist Posted August 12, 2020 Author Share Posted August 12, 2020 Thanks everyone, it's was very helpful. Link to comment Share on other sites More sharing options...
Recommended Posts