Jump to content
Corsair Community

MP600 Firmware Release Notes


Recommended Posts

  • Corsair Employee

For those not seeing the update in SSD Toolbox. Can you try the following:

 

Method 1:

- Open SSD Toolbox

- Run FW update check

- If it doesn't show an available update, leave computer on with SSD Toolbox open

 

If after a few hours it's still not showing an available update try

 

Method 2:

- Open command prompt

- Type "ipconfig /release all" and press enter

- Type "ipconfig /renew" and press enter

- Open SSD Toolbox and run the FW update check

 

If that doesn't work, try

 

Method 3:

- Shut down computer

- Physically uninstall the MP600

- Reinstall MP600

- Reboot

- Run the FW update check in SSD toolbox

 

There's a caching oddity in Windows with the Toolbox that prevents it from seeing an updated version of a backend file that SHOULD have the newest FW listed on there.

 

I personally experienced this just now and was able to circumvent the issue by doing this. I'm going to attempt to replicate the issue on another system, and I'll share my findings.

Edited by Corsair Kevin
Link to comment
Share on other sites

For those not seeing the update in SSD Toolbox. Can you try the following:

 

Method 1:

- Open command prompt

- Type "ipconfig /release all" and press enter

- Type "ipconfig /renew" and press enter

- Open SSD Toolbox and run the FW update check

 

If that doesn't work, try

 

Method 2:

 

- Shut down computer

- Physically uninstall the MP600

- Reinstall MP600

- Reboot

- Run the FW update check in SSD toolbox

 

There's a caching oddity in Windows with the Toolbox that prevents it from seeing an updated version of a backend file that SHOULD have the newest FW listed on there.

 

I personally experienced this just now and was able to circumvent the issue by doing this. I'm going to attempt to replicate the issue on another system, and I'll share my findings.

 

Thank you for posting the firmware update info! I just applied the update without a problem using the SSD Toolbox. It found the new firmware just fine and applied it to the drive. Windows 10 1903 ver 18362.356

Link to comment
Share on other sites

  • Corsair Employee
This metod worked for me

Method 1:

- Open command prompt

- Type "ipconfig /release all" and press enter

- Type "ipconfig /renew" and press enter

- Open SSD Toolbox and run the FW update check

 

That's great to hear! Can you re-run the Crystal Disk Mark tests as mentioned in the other thread? Really want to make sure you're getting the most out of your SSD.

Link to comment
Share on other sites

  • 2 months later...
  • 1 month later...
Guest
This topic is now closed to further replies.
×
×
  • Create New...