Questions Corsair Link + commander mini build

Hello,

With the cosair commander Mini + corsair Link, can one regulate a pump of another brand that is in PWM? (For a custom loop)

Can we have two commander mini on the same PC? How was detected in Link?

Can we connect more than 6 fans to a commander mini? If yes, how?

Thanks in advance for all these answers

Rom

1. The CL mini can control any make of PWM fan or pump.
   
2. I have tested with 4 x CL Mini on this system.
   
3. Yes, but you need to make sure the total current is < 4 amps, see http://forum.corsair.com/forums/showthread.php?t=156661.
   
4. To connect > 6 use a 4-pin PWM Y cable such as http://www.ebay.com/itm/322248465050

Ok thanks for those answers.

I would like to control 7 x NB-eLoop® Series

140mm B14-PS + 1 x EK-XRES 140 Revo D5 PWM + 1 x Led strip RGB.

It will work with a single mini drive? Or is it better that I take two?

I can't tell as you have failed to specify the URL to their specification.

Why can't you add up the current requirement yourself?

Ok thanks for those answers.

I would like to control 7 x NB-eLoop® Series

140mm B14-PS + 1 x EK-XRES 140 Revo D5 PWM + 1 x Led strip RGB.

 

It will work with a single mini drive? Or is it better that I take two?

Sorry, i wanted to say:

"It will work with one single commander mini? Or is it better that I take two?"

1 x NB-eLoop® Series 140mm B14-PS = 0.15 amps

http://www.pcgameshardware.de/Luftkuehlung-Hardware-217993/Specials/Noiseblocker-Eloop-140-mm-Test-Review-1183359/

and the 1 x EK-XRES 140 Revo D5 PWM = 2 amps

well it's good

The https://www.ekwb.com/shop/ek-xres-140-revo-d5-pwm-incl-pump is molex powered so it's just the fans current the CL mini needs to supply and as the total is 1.05 amps that will be fine.

If you just use 1 x CL Mini then only the pump + 5 x fan speeds can be reported. I would use 2 x CL Mini so that all could be reported, but it's down to what you wish.