knappage Posted March 28, 2020 Share Posted March 28, 2020 Hello, I've been using the iCUE software for about 8 months now, but I recently encountered a problem when updating the software to the latest release. I use the Corsair K70 RGB MK.2 keyboard and the Dark Core RGB SE mouse. The keyboard and mouse each have three on-board hardware profiles. I had previously been able (or rather, iCUE did this on its own prior to the update) to skip these hardware profiles when using the 'profile switch' button on my mouse (button between right and left mouse buttons). Now, after the update, the software cycles through all of these profiles when I press the button. Since I don't use these profiles due to always running iCUE, it's a bit annoying to have to cycle through an extra six unused profiles, just to get back to the one or two I typically use. I've tried deleting these hardware profiles from the list of profiles in iCUE, and this works fine. However, every time I restart my computer, they reappear in the list of profiles. Is there any way to permanently remove them from the list (ie. prevent them from returning after computer reboot)? If not, is it possible to skip the hardware profiles when I cycle through the profiles using my mouse (ie. make it the way it used to work)? Any help is appreciated. Thanks! Link to comment Share on other sites More sharing options...
More_Power Posted March 31, 2020 Share Posted March 31, 2020 I'm experiencing a similar issue but my HW profiles stopped working. See the link below... https://forum.corsair.com/v3/showthread.php?t=195013 Link to comment Share on other sites More sharing options...
Deam Posted April 28, 2020 Share Posted April 28, 2020 I just wanted to reiterate this issue. I have the same issue with my K95 Platinum. The hardware profiles now show up on the profile list and get cycled through. If I remove them, they come back. Link to comment Share on other sites More sharing options...
WickedSlammy Posted May 20, 2020 Share Posted May 20, 2020 yes you can delete the hardware profiles. Under each device theres a tab for ONBOARD Profiles, click on each of the 3 and hit CLEAR. That should do it Link to comment Share on other sites More sharing options...
Darkness93 Posted May 11, 2021 Share Posted May 11, 2021 yes you can delete the hardware profiles. Under each device theres a tab for ONBOARD Profiles, click on each of the 3 and hit CLEAR. That should do it This is basically it, though with the latest update it's more like; Click on the Device > Device Settings > Click "Clear All" under "Onboard Memory" Can confirm this works on 4.10.273 after restarting the ICUE App; the hardware profiles are gone and never to be seen again! Until maybe another software update. Link to comment Share on other sites More sharing options...
Recommended Posts