MajorPain Posted September 11, 2020 Share Posted September 11, 2020 (edited) Hey guys, Just looking to get some advice on my H115i AIO tubes. I have a micro ATX case and am struggling to run the tubes in a way that doesn’t rub/push on the back of the gpu. Can anyone let me know if they think this tubing run will be ok or is it too twisted? (Image attached!) Edited September 11, 2020 by MajorPain Link to comment Share on other sites More sharing options...
c-attack Posted September 11, 2020 Share Posted September 11, 2020 That's fine. There are no sharp bends that might weaken the tube over time. The pump has to move the fluid a fixed distance against gravity no matter what you do with the tubes. Typically this is a non-issue in AIO systems with 1 block, 1 radiator, and a relatively short length to travel. Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Art Posted September 11, 2020 Corsair Employee Share Posted September 11, 2020 Hey guys, Just looking to get some advice on my H115i AIO tubes. I have a micro ATX case and am struggling to run the tubes in a way that doesn’t rub/push on the back of the gpu. Can anyone let me know if they think this tubing run will be ok or is it too twisted? (Image attached!) All good! I have something "worse" in a 500D with a H150i Pro without issues! -Art Link to comment Share on other sites More sharing options...
MajorPain Posted September 11, 2020 Author Share Posted September 11, 2020 Awesome thank you both, appreciate the advice! Link to comment Share on other sites More sharing options...
Pocah Posted September 14, 2020 Share Posted September 14, 2020 the thing that would worry me more is that those tubes are pretty difficult to bend. Doesn't that place rather a lot of "twist" on the pump? I mean I have had motherboards crack with less. Link to comment Share on other sites More sharing options...
Recommended Posts