mmfish Posted December 27, 2018 Share Posted December 27, 2018 MSI MEG Z390 GODLIKE LGA 115 is listed as an extended atx will it fit in the 570x case? Thank you for your help. Link to comment Share on other sites More sharing options...
Zotty Posted December 27, 2018 Share Posted December 27, 2018 Hi Buddy,,, not tried it my self,,, but there is more info here http://forum.corsair.com/v3/showthread.php?t=170083 Link to comment Share on other sites More sharing options...
mmfish Posted December 29, 2018 Author Share Posted December 29, 2018 In build referenced a ROG Rampage V Edition 10 was used. It's an E-ATX board, 12inch x 10.8 inch (30.5 cm x 27.2 cm). These are same dimensions of MSI Z390 GODLIKE LGA 115, an E-ATX board. If E-ATX boards fit why not listed in 570x specifications? Link to comment Share on other sites More sharing options...
DevBiker Posted December 29, 2018 Share Posted December 29, 2018 E-ATX isn't a formal specification and has no meaning except "It's bigger than standard ATX". So putting it on the specs for a case is kinda pointless, especially if the case will fit some "E-ATX" boards and not others. Link to comment Share on other sites More sharing options...
mmfish Posted December 29, 2018 Author Share Posted December 29, 2018 As I did today, best way to check motherboard size accommodations, use a tape rule and measure case location for motherboard. Compare that to dimensions listed for each motherboard. An E-ATX board "fits" in a 570x overlapping pass thru grommets. There appears to be standardization of each motherboard classifications. Link to comment Share on other sites More sharing options...
mmfish Posted December 29, 2018 Author Share Posted December 29, 2018 Between E-ATX and ATX 12inch height is same, width difference of close to an inch. Link to comment Share on other sites More sharing options...
DevBiker Posted December 30, 2018 Share Posted December 30, 2018 The height is usually the same. The width can be anywhere from 9.7" to 13". There is no standard single size except that it's "larger than ATX". So yes, measuring is a good idea. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.