deees Posted February 11, 2015 Share Posted February 11, 2015 Anyone know the thickness of the sheet metal used in the 900D, (specifically on the rear fan grill?) I'm switching back to air-cooling, (cause I'm chicken), and the one I need to change on the case before switched to the H100i was to remove the stamped rear grill, (I'm sure that Corsair uses the stamped grill to reduce cost, but couldn't they make it a separate piece and stamp a large hole in the case itself?) I'm looking at picking up a nibbler to cut out the grill. The battery for my caliper is dead, and I'll have run to the battery store to get one that'll fit. Link to comment Share on other sites More sharing options...
deees Posted February 21, 2015 Author Share Posted February 21, 2015 To answer my own question, now that I have new batteries for my caliper, the thickness at the read of the case is approximately 0.03" or 0.76mm. This would put it in the neighborhood of 22 gauge. And since no one answered this question in over a week, I'm obviously the smartest person on the planet:sigh!: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.