SANIC HEGEHOG Posted October 20, 2011 Share Posted October 20, 2011 Hi there everyone, The corsair dominator memory I currently use is not running at 533/1066 MHz. (specs in profile). To what should I change my settings in order for the memory to run at 1066 MHz? My FSB has a frequency of 1066 MHz, so it should be supported. (I installed all modules in a set according to their kit, so the set in Slot #1 and Slot #3 = Revision 2.10 | Slot #2 and Slot # 4 = Revision 1.1) If 533/1066 MHz isn't possible/favorable, then what would the best settings be for these specs? http://localhostr.com/files/DD8rcRc/CPU-z.png PS: I'm upgrading my mobo to a [P5Q DELUXE] + [intel Core 2 Quad Q9550] in about 7 months, so perhaps it would be easier using that setup? P.P.S: I understand that mixing kits will limit the capabilities and maximum stable frequencies, but I chose 2 kits that match as closely as possible. Unfortunately they are of different revisions. Thanks, Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted October 20, 2011 Corsair Employee Share Posted October 20, 2011 When you fill all four slots on that MB and CPU you may be limited to DDR667 or DDR800 and its hit and miss when mixing memory like that. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.