klk Posted September 14, 2020 Share Posted September 14, 2020 Hello, just got my new SE white h100i the screws are not of correct size or rad holes are not correct size as the issue is while fitting fans on rad with long screw only a little bit of screw goes to rad and like 0.3cm screw stays open even with fan making fan move up and down as this is it all 8 holes fixed this by using double rubber washer which i had this is just not how its supposed to work still i worked around it now while fitting rad to case top the small screws from case to RAD same case screw cannot fit leaving screw open even with washer now you can except me to throw 32 washers now its not like you guys provided even a single washer with it case is Corsair c70 and i was using h115 before so well aware of how things work and i tried applying pressure and force . attached pic of case top to see how it looks Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Mint Posted September 14, 2020 Corsair Employee Share Posted September 14, 2020 Can you get a photo of the screw holes on the radiator? Perhaps it's not properly threaded? You may want to reach out to Support and they can help you out further. https://help.corsair.com/hc/en-us/requests/new Link to comment Share on other sites More sharing options...
Recommended Posts