will_s Posted February 7, 2020 Share Posted February 7, 2020 Going to change my case and my loop. Going to add a EK-Quantum Kinetic FLT 360 D5 PWM D-RGB - Plexi pump resovoir with the XR5 and XR7 rad on bottom and top of case. Basically removing the XD5 RGB Reservoir/Pump Combo and was wondering would the temp gauge for that work in the FLT 360? Would the pump on the FLT360 be able to coonect to the power Commander and work just the same in the software ie. control speed. I would use Manual settings for pump speed as I hate the Pump and Fan control speeds tha iCue sets btw:the pump details are and the one is red is the important one Pump electrical and mechanical properties: - Motor: Electronically commuted spherical motor - Rated voltage: 12V DC - Power consumption: 23W - Maximum pressure head: 3.9m - Maximum flow: 1500L/h - Maximum system temperature: 60°C - Materials: Stainless steel, PPS-GF40, EPDM O-rings, Aluminium oxide, hard coal - Power connector: 4-Pin Molex- and 4-Pin PWM FAN connector Link to comment Share on other sites More sharing options...
BlaiseP Posted February 7, 2020 Share Posted February 7, 2020 Running the D5 pump should work fine, it uses the same connectors as the XD5. As for the probe, you have additional inlet/outlet ports - you should be able to use the sensor on one of those. Link to comment Share on other sites More sharing options...
will_s Posted February 8, 2020 Author Share Posted February 8, 2020 thanks but looks like due to redesign of the top part of the Dynamic 011 XL the thicker rad wont fit and with rise card wont fit in the bottom either Link to comment Share on other sites More sharing options...
Recommended Posts