HeisenSwag Posted April 24, 2020 Share Posted April 24, 2020 I have just received the Starter Kit. I put it up around my Monitor and connected everything that needed to be connected. Everything worked fine. I played around with it for a while and it looked good, except since I apparently put the controller box on the wrong site of the monitor (behind the bottom left corner while looking at it from the front) so I wanted to turn it to "Counter Clockwise" so I can use Ambient Lighting properly when watching movies etc. The moment I set it to Counter Clockwise it all turned off. And now it will only turn on when I put it into "Dual Monitor" setup for the Lighting Channel. I only have 4 Strips connected from the starter pack but now I can't use Ambilight for the Monitor I want. I do have 2 Monitors but I only want the lighting for one of them. When I force quit the ICUE software, the strips are lit up as usual. When I turn it on they turn off unless I put them to dual Monitor setup. How can I make the 4 Strips I have only focus on the single Monitor I am using? Link to comment Share on other sites More sharing options...
xMacias Posted April 27, 2020 Share Posted April 27, 2020 Have you made sure that the lighting zones are still highlighted for the LS100? Link to comment Share on other sites More sharing options...
Recommended Posts