balema Posted July 7, 2020 Share Posted July 7, 2020 Hallo, I installed as it says at the manual and when I push the power button of the PC the corsair logo flashes for a second and the system doesn't boot. And if I wont switch it off the PC it does this every 4-5 seconds. Can anyone assumes what is going on? Thank you in advance! Link to comment Share on other sites More sharing options...
balema Posted July 11, 2020 Author Share Posted July 11, 2020 Anyone? Please... Link to comment Share on other sites More sharing options...
c-attack Posted July 11, 2020 Share Posted July 11, 2020 If there is a serious problem with the H60 you might get a "CPU boot error" and the BIOS stops you from loading. Usually this is indicated on screen with that phrase. Much older boards or low end MBs might still use beeps, but I have no idea what you're using. What you are describing seems like a boot loop, but it is also possible to unintentionally set the BIOS up to continue to try and boot until you stop it. There isn't enough information to tell. Link to comment Share on other sites More sharing options...
balema Posted July 27, 2020 Author Share Posted July 27, 2020 The problem was that I tighten too much the screws at the motherboard of H60 and it wan bending. When I untightened then is OK now. The topic can close, thank you! Link to comment Share on other sites More sharing options...
Recommended Posts