Skippman Posted February 12, 2020 Share Posted February 12, 2020 Need some information on how to connect all of this as there doesn't seem to be very clear instructions in the manuals. This is all going in a Corsair 800D. Here is what I have: Corsair Commander Pro 3x Corsair ML120 Pro RGB w/ Lighting Node 2x Corsair LL140 Pro RGB w/ Lighting Node 1x Corsair ML140 non RGB Bitspower Temperature Sensor Now here's how I THINK I should connect them: Commander Pro Fan Port 1: LL140 #1 (Rear Case) Fan Port 2: ML120 #1 (Top Radiator, Rear) Fan Port 3: ML120 #2 (Top Radiator, Middle) Fan Port 4: ML120 #3 (Top Radiator, Front) Fan Port 5: LL140 #2 (Center Case Bottom) Fan Port 6: ML140 (Drive Cages) LED 1: Lighting Node Pro #1 LED 2: Temp 1: Bitspower Temperature Probe Lighting Node Pro Port 1: RGB Fan LED Hub #1 Port 2: RGB Fan LED Hub #2 RGB Fan Hub #1 LED Port 1: ML120 #1 (Top Radiator, Rear) LED Port 2: ML120 #2 (Top Radiator, Middle) LED Port 3: ML120 #3 (Top Radiator, Front) RGB Fan Hub #2 LED Port 1: LL140 #1 (Rear Case) LED Port 2: LL140 #2 (Center Case Bottom) I have to do it this way as I cannot connect the ML and LL fans to the same LED hub, is this correct? Is there a better/simpler way to wire this? Link to comment Share on other sites More sharing options...
usna92 Posted February 13, 2020 Share Posted February 13, 2020 If this is all the lighting you have. You can eliminate the Lighting Node Pro. Connect RGB Fan Hub 1 to LED channel 1 on the CoPro and RGB Hub 2 to channel 2. This eliminates a SATA connection and a USB 2.0 header. You can technically connect ML and LL fans together, but you end up with weird lighting artifacts because of different number of lights. You are better off arranging it like you have where they are separated. That should allow you to control all your LL and ML fans and eliminate one device. Hope this helps. -usna92 Link to comment Share on other sites More sharing options...
Recommended Posts