hyperwolf Posted August 19, 2019 Share Posted August 19, 2019 Hey guys! I am a newcomer here and I will be happy to get help from you. Now, my first question is one, though I am pretty experienced in ICT, I could not answer myself. I bought a Jeyi VolleyStar-Pro PCIe adaptor for my Corsair MP510 and this M.2 fits on the adaptor but since the disk is double sided, NAND blocs underneath are touching the PCB, PCB which has copper bands on both sides in the M.2 area but I am not 100% sure it would be safe to use this or any other model, brand of the same adaptor type for heat dissipation because both connector and standoff are very low on these compared to the ones on a motherboard. I read many reviews about them and most purchasers are happy but I have note been able to find information or pictures about using these adaptors with a double sided M.2. Your opinion? Thanks in adavance for your help, hype. Link to comment Share on other sites More sharing options...
Yemble Posted August 19, 2019 Share Posted August 19, 2019 Can't you just place a thin electrical insulation sheet between the two PCBs? Link to comment Share on other sites More sharing options...
hyperwolf Posted August 19, 2019 Author Share Posted August 19, 2019 I don't think there is a need for electrical insulation since only NAND blocs are in contact with the adaptor PCB. Now the question is and remains: is it going to be safe on thermal dissipation side? Link to comment Share on other sites More sharing options...
hyperwolf Posted August 19, 2019 Author Share Posted August 19, 2019 I found the solution! First thing you must know, there is finally a little, very little gap between the underside and the adaptor PCB ( I found out looking at the sky with the device perpendicular to me shoulders ) but no way you can even apply the thin thermal pad ( adaptor comes with one thin and one a bit thicker ) because doing so makes it impossible for you to screw all the way down the M.2 on its standoff without breaking it. No way to put it on top either ( this is on design ), it goes underneath - only - if you have a one sided M.2.If you put it on top the heatsink of the adaptor will be pushing on your M.2 enough for the NAND modules underneath to touch PCB. Now, I have applied the thin thermal pad on top and nothing on the underside. This is the best way to do it: good thermal transfer on top and since the NAND modules are anyway very close to the copper bands on PCB, it does pretty well on that side too. Now one last thing, the stickers on any M.2 drive are not electrically conductive so if for any reason ( thermal expansion... ) the NAND blocs are coming in contact with PCB there should be no problem. More, since this drive will not be my system one it will most probably not generate a lot of heat. O.K. guys, hope this could help other members some given time,see you all! :-P Link to comment Share on other sites More sharing options...
hyperwolf Posted August 24, 2019 Author Share Posted August 24, 2019 There is very thin thermally conductive tape sold on Amazon ( 0.15 mm ), should I give it a try? Link to comment Share on other sites More sharing options...
Recommended Posts