Jump to content
Corsair Community

New purchase, Force 3 60G/90G drives


Governator

Recommended Posts

Hi, I just purchased these two drives and so far all is well where I have them installed upon my EVGA E760 Classified mobo connected to a Syba SY-PEX40039 SATA III adapter card installed in an x8 slot where the performance was much better than when installed in an x1 slot. I get around 380MB/s max transfer rate as I'd expect upon the x58 and x8 slot given the limitation of the chipset and controller chip (ASMEDIA 1061). I will move the 60G (which will hold BF3 by itself) to a new Marvell 9128 chip adapter and retain the 90G which has OS boot upon it.

 

I've now updated both drives to the 1.3.2 fw update (process went w/o a hitch) and that took care of the bogus temp reading error on the 90G but not the 60G, though there is again, no temp issue, both drives being cool as a cucumber. What may be the issue with the 60G on this? Thanks everyone.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...