Jump to content
Corsair Community

h100i


SyNc

Recommended Posts

I have an H110i GT and I can change the pump speed on that with Link 4.3 and I used to have a couple (3) of H100i's that could be changed by earlier versions of Link, so either there's a problem with your cooler or with your Link installation. I can't think of anything else, I'm afraid. Perhaps c-attack will be along in a while, he usually has some insightful thoughts.
Link to comment
Share on other sites

there is no option and changing the profile does nothing to the pump always the same speed

 

#Have you got the HDMI connected into the main motherboard if not it wont report the pump speeds. I got the NZXT USB extension and when I connect the lead from the pump to the unit it wont work. The USB that I have connected for the front of the case works fine!! I must connect the USB from the pump directly to the motherboard then it works fine. I might have a faulty NZXT unit? If someone has a fix for this I would like to know.

Cheers.

Mike

 

30634303831_35d9fea4c9_h.jpg20161031_140515 by Mike Skerritt, on Flickr

 

https://c6.staticflickr.com/6/5336/30087838373_20420f5e6a_h.jpg' alt='30087838373_20420f5e6a_h.jpg'>20161031_140431 by Mike Skerritt, on Flickr

 

30064920614_7488bc1f21_b.jpgCPU-Z Stress test by Mike Skerritt, on Flickr

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...