Litorog Posted September 11, 2012 Share Posted September 11, 2012 Hello I just bought the corsair link kit and gpu but Im confuse I need some help on gpu link with come 4 cables 1 4 pins 2 pci and analog cable where I connect the analog cable to corsair command or to cooling node please help? Link to comment Share on other sites More sharing options...
peanutz94 Posted September 11, 2012 Share Posted September 11, 2012 where I connect the analog cable to corsair command or to cooling node please help? If you mean the data cable, one end should go to the GPU node and the other to the commander. Any chance you could take a pic of the cable in question just to be sure? Link to comment Share on other sites More sharing options...
Reedy Posted October 5, 2012 Share Posted October 5, 2012 If you're still confused, this answer is somewhat helpful: The GPU node will have to connect directly you cannot use adapters... The white 4-Pin Molex will connect to your PSU and the 2-Pin will connect to the cooling node and the 2 6+2 cables are for the Video Card (Note if you have a VIDEO card that only requires one connection I would still suggest connecting both Power leads from the PSU), and your PSU must have PCI-E cables you cannot adapt 4 Pin Molex to PCI-E. Then once you have Corsair Link installed go to devices and high light the device and change it from a TEMP device to a POWER device then it should show the power other wise it will think it is a TEMP sensor The 2 pin cable goes onto one of the "sensors" of the cooling node Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.