tweakmon Posted April 4, 2010 Share Posted April 4, 2010 Hello. I just set up my R60's in raid 0 on asus crosshair3 mobo. Here is the ATTO benchmark I get with 128k stripe and Win 7 x64 setup partitioning allocation http://www.tweakmonster.com/miscstuff/downloads/r60bench.jpg: Does this look OK, or should I possibly try something else to get more out of it? This was with fresh install with only amd raid driver. Also, I have ben reading a bit about TRIM, and I know that the SB750 does not seem to support it when running raid. Is this a concern? Am I going to have issues later on with available drive space not being seen? Thanks. Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted April 5, 2010 Corsair Employee Share Posted April 5, 2010 Yes you are in line with the performance spec of the drives at 250 MB/s sequential read and 110 MB/s sequential write for a single R-60 drive. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.