twolettersins Posted June 21, 2020 Share Posted June 21, 2020 Hey Corsair peeps Just wondering if someone could measure their XD5 for me? Chasing the measurements of each individual section of the pump/res combo. Reservoir compartment height and width Pump height and width Playing with some very tight tolerances in a 280x so needing specifics before placing my order to ensure it'll fit where I want it to go Reason for needing the individual component measurements is that I am hoping the reservoir section is thin enough to go between the gpu block and front rad with the pump section sitting just below the bottom of the block Link to comment Share on other sites More sharing options...
Salsiccia Posted June 26, 2020 Share Posted June 26, 2020 I have on mine: - Res height - 114mm - Res width - 64 mm - Pump height - 68mm - Pump width - 80mm (taken on the plastic shroud at the bottom of the res. This will be wider if you add fittings to the width, depends which holes you want your fittings in. Good luck ! Link to comment Share on other sites More sharing options...
Salsiccia Posted June 30, 2020 Share Posted June 30, 2020 You're welcome ;-) Link to comment Share on other sites More sharing options...
MrRandomChicken Posted July 14, 2020 Share Posted July 14, 2020 Did you manage to get this setup working? Looking to do the same thing as I prefer the look of the XD5 to the XD3 and would love to see how it turned out if possible! Link to comment Share on other sites More sharing options...
Recommended Posts