Haku Posted July 23, 2019 Share Posted July 23, 2019 Hi I want to attach the ball valve to one of the ports at the bottom of the pump/res. How would i do that? Do i need some other part in between? I found another thread where someone mentioned about the Y-splitter, do i need the bottom part of that one? Sorry for noob question. First time touching anything to do with water cooling :) Thanks. Link to comment Share on other sites More sharing options...
skyteam78 Posted July 23, 2019 Share Posted July 23, 2019 Hey. No you don't need Y-splitter. You can attach it to the right (marked as inlet port) in the manual. But you need to use some male to male extender. I can suggest bitspower male to male rotary G1/4 extender. like this one: https://www.amazon.com/Bitspower-Extender-Fitting-Rotary-Sparkle/dp/B003U3TUDC Link to comment Share on other sites More sharing options...
Haku Posted July 23, 2019 Author Share Posted July 23, 2019 Hey. No you don't need Y-splitter. You can attach it to the right (marked as inlet port) in the manual. But you need to use some male to male extender. I can suggest bitspower male to male rotary G1/4 extender. like this one: https://www.amazon.com/Bitspower-Extender-Fitting-Rotary-Sparkle/dp/B003U3TUDC Ok thanks, but does this part not exist in any of the Corsair products? If i have to order it from Amazon its gonna take ages to ship it here :) Link to comment Share on other sites More sharing options...
Recommended Posts