Mr Pabl0 Posted December 2, 2005 Share Posted December 2, 2005 Hello ! Since I bought my modules Ii was thinking that something was wrong. After lot of cracsh games, I ran MemTest+ 1.65 and after 15 minutes of testing : 578 Errors (if I remember right and the computer turned itself off) :,( My config : PC : Shuttle SB75G2 MB : FB75 Bios S01D PS : 250W HD : 2 Seagate 160 Go RAID 0 GC : MSI RX800 XT PE CPU : Intel P4 C 3 GhZ CD-ROM : PLEXTOR PX-708A RAM : Dual Channel Enabled, Frequency DDR-400, Voltage : 2.75V As you can see, no overlocking. So, what's next ? Thank you. Link to comment Share on other sites More sharing options...
milleron Posted December 2, 2005 Share Posted December 2, 2005 I believe that 3200XL modules require at least 2.8 v. Try increasing the DRAM voltage to 2.8 and rerun Memtest86. If you still get errors, you can try it at 2.85 and 2.90 volts. Corsair does not warrant it for use at voltages above 2.9, however, so I'd suggest not going higher than that. Ron Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted December 2, 2005 Corsair Employee Share Posted December 2, 2005 Please set the Dim Voltage to 2.7X volts and then set the timings manually to the tested settings for the specific module you have, and then test the module/modules one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. Link to comment Share on other sites More sharing options...
Mr Pabl0 Posted December 3, 2005 Author Share Posted December 3, 2005 Ok. Thanx ! I will do that this week-end and keep you update. Cya ! Link to comment Share on other sites More sharing options...
Wired Posted December 3, 2005 Share Posted December 3, 2005 Timings for 2 sticks: CAS Latency (tCL): 2 RAS to CAS Delay (tRCD): 2 Row Precharge (tRP): 2 Active to Precharge Delay (tRAS): 5 Memory Voltage: 2.75 Volts All other settings to defaults. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.