jrwininger Posted July 13, 2019 Share Posted July 13, 2019 I'm getting conflicting information on the proper way to prep the Corsair hard tube endings. Is it enough to just sand and smooth the ends after cutting? Or is a chamfer (sloping edge) necessary? Link to comment Share on other sites More sharing options...
Zotty Posted July 13, 2019 Share Posted July 13, 2019 Hi Buddy, Smooth with no sharp edges is what you are after.. its mostly about not damaging the Orings as the tubing goes into the fittings..... Link to comment Share on other sites More sharing options...
jrwininger Posted July 13, 2019 Author Share Posted July 13, 2019 Hi Buddy, Smooth with no sharp edges is what you are after.. its mostly about not damaging the Orings as the tubing goes into the fittings..... Thanks. Is it possible to buy replacements for the inner o-rings? I don’t see replacements on the CORSAIR site. Can they be purchased from a Bitspower reseller? Link to comment Share on other sites More sharing options...
Zotty Posted July 13, 2019 Share Posted July 13, 2019 Thanks. Is it possible to buy replacements for the inner o-rings? I don’t see replacements on the CORSAIR site. Can they be purchased from a Bitspower reseller? at a guess.... I assume Bitspower rings would fit but don't hold me to it. Link to comment Share on other sites More sharing options...
Recommended Posts