Morrosis Posted April 25, 2019 Share Posted April 25, 2019 Hi all, I have a Commander pro and a H80i v2, all the fans are Noctua NF-F12 Industrial PPC and I have two connected to the Commander pro and the other two connected to the H80i, and it connected to the commander pro as well. At the moment the case fans as you can see in the image are not spinning at the same rpm as the H80i fans. Is there a way I can link them to all spin at the same speed and profile? I tried setting them all to the same group that being the H80i v2 group but the profile for the quite mode is different as seen here for the case fan and here for the H80i any help would be nice Thanks Morrosis Link to comment Share on other sites More sharing options...
Zotty Posted April 25, 2019 Share Posted April 25, 2019 Try Making your own Fan curves up buddy.... and is there a reason you are sticking with LINK? LINK is end of life now.. it's been replaced with iCUE https://www.corsair.com/uk/en/icue Link to comment Share on other sites More sharing options...
Morrosis Posted April 25, 2019 Author Share Posted April 25, 2019 Try Making your own Fan curves up buddy.... and is there a reason you are sticking with LINK? LINK is end of life now.. it's been replaced with iCUE https://www.corsair.com/uk/en/icue I thought iCUE was just for RGB stuff. I will switch over now and give it a go. Link to comment Share on other sites More sharing options...
Zotty Posted April 25, 2019 Share Posted April 25, 2019 I thought iCUE was just for RGB stuff. I will switch over now and give it a go. good luck man.... lots of how to guides here Link to comment Share on other sites More sharing options...
DevBiker Posted April 25, 2019 Share Posted April 25, 2019 Also, your Fan #1 curve is out of line with the radiator fan curve. The point temperatures are different. Link to comment Share on other sites More sharing options...
Recommended Posts