Corsair 180

My 180 has an issue, anyone know how to resolve this

when I switched it on for the first time , it came on and I went straight to bios , while just looking at the screen , the pc rebooted and started again , I went back to bios and it did reboot yet again but this time flashing red on the left pane led strip

I checked online and found it had to do with heat , so I cross checked my fan and found out the fan wasn’t spinning again and I was sure it spun when I powered it on the first time

So I proceeded to check the cable , all good , removed and put them back same issue.

After some back and forth , I decided to plug the fan directly to the mobo header and remove the single pin plug coming from the cpu pump into that header

The fan worked

I managed to finish setup and enter into the icue software and it said

Fan 0rpm , cpu, GpU pump and coolant all spinning 1922,1963 rpm and 27 and 22.6 respectively

Does this mean the pump is bad, since I can’t control the fans thru the single pin ?

Also the GpU fans don’t show any rpm on icue or any other monitoring software

Do they start at a particular temperature or are they also controlled by the single pin removed from the fan header ?

Please advice

replied in PM. Do give us a call if you have other issues.

PM Responded to, thank you