View Single Post
  #2  
Old 09-12-2020, 07:57 AM
c-attack c-attack is offline
Registered User
c-attack's PC Specs
 
Join Date: Jun 2014
Posts: 12,670
POST ID # = 1061060
c-attack c-attack Reputation: 122
Default

You are cutting the voltage to cooler below the point where it can start the PWM fans and also putting a lot of electrical strain on the pump. Both fans and pump are meant to run at 12v. You need to put QFan control for header powering the unit back to “disabled” or “full speed”. Both lock the power supply at 12v. Then you can adjust the fans from within Link using the Configure tab. Click on the fans rpm reading.

However, if you connected the fans to motherboard then it is normal for the AIO fan controller to read 0 rpm and you need to sort things through the BIOS for the fan headers. The pump still needs its 12v and that header still needs to be at disabled/full speed.
Reply With Quote