View Single Post
  #24  
Old 09-04-2009, 03:16 AM
hornett hornett is offline
Registered User
 
Join Date: Sep 2009
Posts: 2
POST ID # = 414912
hornett Reputation: 10
Default

Hi all you are not alone in this problem.

Had the same issue. Found out it was bent pins on the board. What it looks like is happening is the clamp that pulls down on the chip is doing it too much.

If you look at the clamp there are raised sections on either side. One of these is pushing down so hard its squashed some pins.

If you can take a look and see.

If it is I believe this is an issue with the board design as I have seen other posts about the same problem

Regards

Last edited by hornett; 09-04-2009 at 09:25 AM.
Reply With Quote