Thread: Noob to aRGB
View Single Post
  #3  
Old 11-03-2019, 10:38 AM
gravy1958 gravy1958 is offline
Registered User
 
Join Date: Aug 2015
Posts: 4
POST ID # = 1022948
gravy1958 Reputation: 10
Default

Thanks for the reply, I've been checking your videos :)

So if I have 6 aRGB fans and an h100i RGB platinum cooler... the fans will all run using the nodes/ hubs that come with the 680x case and with the 3 fan kit and I can control their rgb using icue?

will there be enough ports for the aio rgb to also plug in or will that need to go through the mobo (gigabyte Aorus, not corsair compatible)

would one or two commanders be needed or not unless I need specific rgb control?

I ask all this because I'm currently building a spec on pcspecialist, the 680x has 3 rgb fans, the cooler has 2 rgb fans and every time I try to add a 3 fan kit, it says I have a compatibility problem and need to remove either the fan kit or the RGB cooler... I'm assuming the configurator sees 8 fans in total and perhaps the hud/node cannot run more fans, but I assume the hub/node in the case is enough to run the case fans and the aio and what hub/node comes with the fan kit would run the 3 fans or daisy chain off the case node/ hub...

perhaps the configurator is assuming I am ordering the fan kit by mistake or maybe it knows I will need a commander 2... I'm not sure, although I have seen cases with 12 fans, so I thought 6 and 2 on the aio would be fine.

Last edited by gravy1958; 11-03-2019 at 10:43 AM.
Reply With Quote