knacker40 Posted September 2, 2019 Share Posted September 2, 2019 Having had the same issues with some Thermaltake clear fluid as in the XSPC thread, is there a list of fluids- apart from Corsair stuff:D:- that either can be recommended or more importantly avoided. Just going through second flush of deionised water in this loop so fingers crossed it will clear after a few more Link to comment Share on other sites More sharing options...
Corsair Employee Corsair GregX Posted September 2, 2019 Corsair Employee Share Posted September 2, 2019 Could you let us know the exact model of Thermaltake clear fluid? Coolant compatibility list can be found under related Hydro X parts, under compatibility tab. Based on your issue with XSPC EC6 coolant, we will monitor and take further actions to validate its position on the list. Link to comment Share on other sites More sharing options...
knacker40 Posted September 2, 2019 Author Share Posted September 2, 2019 it's the C1000 Pure clear- which is on the list Link to comment Share on other sites More sharing options...
Corsair Employee Corsair GregX Posted September 2, 2019 Corsair Employee Share Posted September 2, 2019 Thank you for info. I would recommend to get distilled water for further flushing procedures. Link to comment Share on other sites More sharing options...
knacker40 Posted September 2, 2019 Author Share Posted September 2, 2019 I cant get distilled where I am without it costing as much as the loop itself Link to comment Share on other sites More sharing options...
Zone55555 Posted September 3, 2019 Share Posted September 3, 2019 You can make it without much effort. Here's one guide that's easily followed at home: https://www.instructables.com/id/How-to-Distill-Water/ Link to comment Share on other sites More sharing options...
knacker40 Posted September 5, 2019 Author Share Posted September 5, 2019 Have flushed the loop for past couple of days and is looking not too bad now. I did have to remove the reservoir and clean it out as there was a load of white gunk in it which is odd as I did a thorough clean out of the rads before I started the loop. There is a small spot on the cpu block- more of a stain than anything but doesnt seem to be impacting anything and I dont want to strip it down just yet. Link to comment Share on other sites More sharing options...
Recommended Posts