View Single Post
  #59  
Old 03-29-2019, 02:50 PM
therandomest therandomest is offline
Registered User
 
Join Date: Mar 2019
Posts: 2
POST ID # = 999457
therandomest Reputation: 10
Default

Hello, I'm trying to set up a Corsair RGB system and wanted to check and see if this would work. First, what I'm trying to control:

- 8 LL fans on two quad rads
- 2 ML case fans
- 2 LED strips. These are not Corsair brand (link here: https://www.amazon.com/gp/product/B07KFLC814/) but I've taken off their 3-pin connector and replaced it with one that is compatible with Corsair (Molex 50-57-9403).

My plan was to have one Lightning Node that controlled it all. From one Lightning port, a Y-splitter cable (3-pin, 2-wire) going to two RGB hubs that separately controlled my case fans and my rad fans. The 8 LL fans would require two Y-splitter 4-pin cables to get them into the 6 ports. Then use the other Lightning port to control the LED strips. Would this work? Image below:



corsair.jpg

My main concern is the split cable coming from the Lightning node and the off-brand LED strips.

Any help is much appreciated thanks!
Reply With Quote