MikePhil41 Posted May 14, 2019 Share Posted May 14, 2019 (edited) I Recently bought two LL120 fans and a commander pro and had the 6 port fan splitter given to me by a friend. I have a three pin connecter going from the fan splitter to the commander pro LED slot 1. Then I just have my three pin connecters form my fans going to my fan splitter and the PWM connecters to the commander pro. I really cant figure out why only one is lighting up. Ive switch them out and its not the fans or ports. I've attached a photo for reference. Any help would be greatly appreciated. Edited May 14, 2019 by MikePhil41 Link to comment Share on other sites More sharing options...
DevBiker Posted May 14, 2019 Share Posted May 14, 2019 Did you configure iCUE for the number and type of fans on the channel? Link to comment Share on other sites More sharing options...
MikePhil41 Posted May 14, 2019 Author Share Posted May 14, 2019 In the ICUE software? I'm not seeing that anywhere. The commander pro is reading both of the fans RPM just for some more information. Link to comment Share on other sites More sharing options...
DevBiker Posted May 14, 2019 Share Posted May 14, 2019 You need to go to "Lighting Setup" in iCUE. Then set up the channel that the fans are on (via the Fan Hub) for the type and number of fans. It's not auto-detected. Link to comment Share on other sites More sharing options...
MikePhil41 Posted May 14, 2019 Author Share Posted May 14, 2019 Awesome figured it out, thanks so much. Link to comment Share on other sites More sharing options...
Recommended Posts