The Corsair User Forums  

Go Back   The Corsair User Forums > Search Forums

Notices

Showing results 1 to 25 of 1057
Search took 0.06 seconds.
Search: Posts Made By: emissary42
Forum: Arbeitsspeicher (Memory) 10-18-2020, 10:39 AM
Replies: 9
Views: 174
Posted By emissary42
Ja, das ist ein bekanntes Problem. In der B-Die...

Ja, das ist ein bekanntes Problem. In der B-Die Liste ist es auch erklärt.


Das ist dann bestimmt ein sehr frühes Kit aus 2016?

Die Info zum DRAM Manufacturer wurde von vielen Herstellern...
Forum: Memory 10-18-2020, 12:04 AM
Replies: 3
Views: 282
Posted By emissary42
No luck with 3600 18-21-21 or 3600 18-20-20? ...

No luck with 3600 18-21-21 or 3600 18-20-20?

Usually GDM ON is the easiest for high frequency results. Disabling it only really makes sense if the system is stable with a CR of 1T since GDM ON...
Forum: Arbeitsspeicher (Memory) 10-17-2020, 11:59 PM
Replies: 9
Views: 174
Posted By emissary42
Ver4.32 sind Samsung 8Gbit C-Die Ver4.31 sind...

Ver4.32 sind Samsung 8Gbit C-Die
Ver4.31 sind Samsung 8Gbit B-Die

Generell sollten Samsung 8C mit weniger als 1.4V besser laufen, während Spannungen deutlich über 1.35V den Taktspielraum oft eher...
Forum: Memory 10-05-2020, 01:02 PM
Replies: 3
Views: 237
Posted By emissary42
Has not been tested, so it is not guaranteed to...

Has not been tested, so it is not guaranteed to work. The usual recommendation from tech support is to get a single kit of the required overall capacity.
Forum: Arbeitsspeicher (Memory) 10-04-2020, 05:22 AM
Replies: 10
Views: 492
Posted By emissary42
Liest man oft und ist schlicht falsch. Auch...

Liest man oft und ist schlicht falsch. Auch Samsung 8C lassen sich durchaus übertakten, man muss sie nur anders behandeln als "B-Die". Weil viele User sie auf Grund falscher Thaiphoon...
Forum: Memory 10-02-2020, 12:35 AM
Replies: 1
Views: 183
Posted By emissary42
If the memory gets to hot you would notice...

If the memory gets to hot you would notice instabilities above a certain threshold. Sub 50°C under load actually is not too bad for a RGB model and should be fine.

Some very tight manual settings...
Forum: Memory 09-21-2020, 10:27 AM
Replies: 1
Views: 200
Posted By emissary42
The Vengeance LPX standard SPD speed of...

The Vengeance LPX standard SPD speed of DDR4-2133, so that is what the MB defaults to when they are installed. The actual specs are programmed in a XMP, which has to manually enabled, while the...
Forum: Memory 09-03-2020, 12:41 AM
Replies: 7
Views: 581
Posted By emissary42
Not sure about the packaging but the product page...

Not sure about the packaging but the product page clearly states XMP 2.0 certified and lists a standard profile for DDR4-2133 and a performance profile (= XMP) for DDR4-3000.
Forum: Memory 09-02-2020, 10:10 AM
Replies: 7
Views: 581
Posted By emissary42
There is no need to manually input anything, just...

There is no need to manually input anything, just enable the XMP that contains all of the specifications (frequency, programmed timings and voltage).
Forum: Memory 08-28-2020, 09:52 AM
Replies: 2
Views: 292
Posted By emissary42
Even though it gets thrown around a lot that...

Even though it gets thrown around a lot that formula is of very limited usefulness in my opinion. The two kits are not the same, just because you get 10ns for both kits with it. If you ignore all...
Forum: Memory 08-27-2020, 07:04 AM
Replies: 2
Views: 374
Posted By emissary42
Don't know the clearance of your case/AIO combo,...

Don't know the clearance of your case/AIO combo, but if you don't need RGB memory Vengeance LPX are probably your best bet, when it comes to low profile Corsair memory. Their height is just 31mm...
Forum: Memory 08-27-2020, 06:59 AM
Replies: 6
Views: 400
Posted By emissary42
Ver4.32 is Samsung 8Gbit C-Die and because of...

Ver4.32 is Samsung 8Gbit C-Die and because of their lower voltage tolerance there is not as much room to tighten timings, as is with other IC types. Going over 1.35V will not always help with...
Forum: Arbeitsspeicher (Memory) 08-25-2020, 10:25 PM
Replies: 4
Views: 335
Posted By emissary42
Teste das neue Kit noch mal einzeln in DIMM A2/B2...

Teste das neue Kit noch mal einzeln in DIMM A2/B2 und setze nach dem Einbau zur Sicherheit das CMOS des Mainboards zurück, bevor du das XMP wieder manuell aktivierst.

Wenn der PC selbst mit...
Forum: Arbeitsspeicher (Memory) 08-24-2020, 07:58 PM
Replies: 10
Views: 492
Posted By emissary42
Wenn du damit nicht weiter kommst, teste beide...

Wenn du damit nicht weiter kommst, teste beide Module einzeln im Steckplatz A2.

Edit: Achtung Thaiphoon Burner erkennt den DRAM Hersteller bei Corsair Modellen nicht immer korrekt, daher ist es...
Forum: Memory 07-13-2020, 03:43 AM
Replies: 7
Views: 518
Posted By emissary42
The part number looks like a Corsair one but is a...

The part number looks like a Corsair one but is a bit funky, as if the memory is an OEM part or for one of the Corsair One/Vengeance systems.

Can you post the link to the shop/article you bought?
Forum: Memory 07-12-2020, 02:34 AM
Replies: 2
Views: 473
Posted By emissary42
Compare the specifications and stated...

Compare the specifications and stated compatibility on the product pages. The timings and the general SPD programming is different, as is AMD compatibility between both kits.
Forum: Arbeitsspeicher (Memory) 06-24-2020, 01:54 PM
Replies: 3
Views: 447
Posted By emissary42
Als normaler User gesprochen: Ich würde bei einem...

Als normaler User gesprochen: Ich würde bei einem Z390 Mainboard und Kits mit solchen sehr gemäßigten Spezifikationen tendenziell keine Probleme erwarten.

Die MB Hersteller testen für Ihre QVL...
Forum: Memory 06-24-2020, 01:44 PM
Replies: 7
Views: 753
Posted By emissary42
They might be, but what do you require such...

They might be, but what do you require such voltages for?
Was your Godlike able to hit 4133/4200 at CL19?

In most cases it is not worth it for daily settings to go full out on voltage, unless...
Forum: Memory 06-18-2020, 10:04 PM
Replies: 2
Views: 608
Posted By emissary42
Ver4.32 is not B-Die but Samsung 8Gbit C-Die...

Ver4.32 is not B-Die but Samsung 8Gbit C-Die instead and I don't think the "Calculator" is very useful for them.

With four sticks and a 2600X/X470 combo I would test if the XMP does work at a...
Forum: Memory 06-16-2020, 09:36 PM
Replies: 7
Views: 753
Posted By emissary42
So they are some kind of Micron 8Gbit IC, from...

So they are some kind of Micron 8Gbit IC, from your result probably E-Die.
Forum: Memory 06-16-2020, 12:50 PM
Replies: 7
Views: 753
Posted By emissary42
If you already own them, you can check the...

If you already own them, you can check the version number on the modules for the IC info or use Thaiphoon Burner to confirm it. For now I would expect these to still be Ver4.31 and therewith Samsung...
Forum: Arbeitsspeicher (Memory) 06-08-2020, 07:16 AM
Replies: 3
Views: 531
Posted By emissary42
Die auf den Produktseiten ausgewiesene...

Die auf den Produktseiten ausgewiesene Kompatibilität mit unerschiedlichen Plattformen kann sich unterscheiden. Die Z-Modelle waren ursprünglich alle explizit als kompatibel mit den AMD Ryzen (Zen)...
Forum: Memory 06-06-2020, 01:07 PM
Replies: 21
Views: 1,311
Posted By emissary42
The version number Ver4.31 does indicate Samsung...

The version number Ver4.31 does indicate Samsung 8GBit B-Die. Can you please upload a TB screenshot for that one?
Forum: Memory 06-03-2020, 05:04 PM
Replies: 4
Views: 2,187
Posted By emissary42
DDR4-3600 should be possible if your setup can...

DDR4-3600 should be possible if your setup can handle it. If have tested modules based on the same type of DRAM IC (Samsung 8Gbit C-Die) up to DDR4-4133 and others managed to reach 3800/1900 on X570....
Forum: Memory 06-03-2020, 04:58 PM
Replies: 3
Views: 444
Posted By emissary42
Experiences with certain models can differ even...

Experiences with certain models can differ even if all the components are the same. However there is no point in stressing yourself over that. Make sure you use the correct DIMM slots and just try if...
Showing results 1 to 25 of 1057

 
Forum Jump

All times are GMT -4. The time now is 01:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.