Jump to content

rschissler

Members
  • Posts

    49
  • Joined

Reputation

10 Good
  1. I did install the Gigabyte software for controlling the fans, etc. When trying to set a minimum rpm at say 400rpm, it seems to do it by bouncing back and forth from 0 to 400. Not a big deal I guess, I may just go back to the default setting, which is 0rpms until 60 degrees C, then kicks into high gear. Apparently, they must think that is OK.
  2. Thanks, I just read that there is a minimum threshold before the fans turn on. Can Commander Link control it as I think I would like a minimum speed rather than no speed until getting hot?
  3. On my Gigabyte GeForce 1050 Ti, the fans are not working. This is a new build, and I'm embarrassed to say I don't know if they weren't working from the start, which was a couple weeks ago. I just noticed it in Commander Link, which has only been running for a couple days. Link recognizes it but the rpms are zero. I verified it by looking at the fans and they are not spinning. I checked device manager and I don't see anything amiss. My monitor is connected to the card, and everything else seems fine, so I'm not sure what the deal is. Any ideas?
×
×
  • Create New...